Paper
21 October 1996 Outdoor, indoor, and human breath content measurements of ammonia by tunable diode laser spectroscopy technique
Konstantin L. Moskalenko, Alexander I. Nadezhdinskii
Author Affiliations +
Abstract
Trace contents of ammonia in outdoor, indoor and exhaled air were measured on the base of high resolution absorption spectra. Tunable diode laser system developed for this purpose possesses approximately one second time constant, approximately 200 cm3 sample volume, 5 ppb sensitivity. The calibration of unit was based on measurements of relative intensities of sQ(3,1)...sQ(3,3) absorption lines of v2s and following calculation on the base of a priori data on strength and broadening coefficients of detected lines. Measured indoor contents of ammonia was in 5-10 times higher than outdoor contents. Approximately two times drop in NH3 room content after 6 p.m. was detected. Obtained behavior of ammonia content in respiration right after the smoking demonstrates that the removing of ammonia from lungs has the ventilation character. Measured contents of NH3 in human respiration was ranged between 120 and 220 ppb. The absence of ammonia content differences from respiration of smoking and non smoking persons demonstrates that the accumulation of NH3 by human organism seems to be rather negligible for a short time exposure, e.g. like smoking.
© (1996) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Konstantin L. Moskalenko and Alexander I. Nadezhdinskii "Outdoor, indoor, and human breath content measurements of ammonia by tunable diode laser spectroscopy technique", Proc. SPIE 2834, Application of Tunable Diode and Other Infrared Sources for Atmospheric Studies and Industrial Process Monitoring, (21 October 1996); https://doi.org/10.1117/12.255330
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Absorption

Tunable diode lasers

Laser spectroscopy

Signal to noise ratio

Spectroscopy

Safety

Calibration

Back to Top