Paper
23 September 2009 Mask performance improvement with mapping
Author Affiliations +
Abstract
Current high end chips require an extremely precise fabrication of lithographic masks. Some of the most critical parameters are the placement of structures on the masks as well as their dimensional tolerances. Improving these two key parameters has always been one of the central objectives of the Advanced Mask Technology Center (AMTC). To this end, the AMTC has complemented its process development by a set of enhancement schemes which are used to compensate residual process signatures. In this paper, improvements achieved in the area of CD uniformity (CDU) and pattern placement are shown. The correction schemes take first principle considerations as well as empirical findings into account. Based on this, a set of design and process parameters is used to determine the spatial corrections which will optimize mask quality parameters. This enables the AMTC to tailor the writing parameters to the needs of each mask design. Latest results for the 32nm technology show that values as low as 5nm image placement error and 3nm CDU can be reached at the same time.
© (2009) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Clemens Utzny, Eric Cotte, Timo Wandel, and Jan Hendrik Peters "Mask performance improvement with mapping", Proc. SPIE 7488, Photomask Technology 2009, 74880N (23 September 2009); https://doi.org/10.1117/12.834302
Lens.org Logo
CITATIONS
Cited by 2 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Photomasks

Critical dimension metrology

Signal to noise ratio

Principal component analysis

Process control

Electron beam melting

Error analysis

Back to Top