Paper
7 February 2012 Progress on single mode VCSELs for data- and tele-communications
Nikolay N. Ledentsov, James A. Lott, Jörg-R. Kropp, Vitaly A. Shchukin, Dieter Bimberg, Philip Moser, Gerrit Fiol, Alexey S. Payusov, Denis Molin, Gerard Kuyt, Adrian Amezcua, Leonid Ya. Karachinsky, Sergey A. Blokhin, Innokenty I. Novikov, Nikolay A. Maleev, Christoph Caspar, Ronald Freund
Author Affiliations +
Abstract
Single mode (SM) 850 nm vertical-cavity surface-emitting lasers (VCSELs) are suitable for error-free (bit error ratio <10-12) data transmission at 17-25 Gb/s at distances ~2-0.6 km over 50μm-core multimode fiber (MMF). Reduced chromatic dispersion due to ultralow chirp of SM VCSELs under high speed modulation (up to 40 Gb/s) are responsible for the dramatic length extension. Good coupling tolerances of the SM devices to the MMF manifest their applicability for low cost optical interconnects. As the higher resonance frequency (up to 30 GHz) is reached at lower current densities in small aperture (3 μm -diameter) devices the SM devices are also preferable due to reliability considerations.
© (2012) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Nikolay N. Ledentsov, James A. Lott, Jörg-R. Kropp, Vitaly A. Shchukin, Dieter Bimberg, Philip Moser, Gerrit Fiol, Alexey S. Payusov, Denis Molin, Gerard Kuyt, Adrian Amezcua, Leonid Ya. Karachinsky, Sergey A. Blokhin, Innokenty I. Novikov, Nikolay A. Maleev, Christoph Caspar, and Ronald Freund "Progress on single mode VCSELs for data- and tele-communications", Proc. SPIE 8276, Vertical-Cavity Surface-Emitting Lasers XVI, 82760K (7 February 2012); https://doi.org/10.1117/12.902643
Lens.org Logo
CITATIONS
Cited by 18 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Vertical cavity surface emitting lasers

Modulation

Data transmission

Multimode fibers

Reliability

Standards development

Temperature metrology

Back to Top