Professional expertise: XUV Spectroscopy of the Solar Corona and Solar Wind; determination of physical parameters of Coronal Streamers and Coronal Mass Ejections; comparison between plasma parameters derived via remote-sensing techniques and in situ parameters measured by Ulysses instruments; Earth – Sun connections and Space Weather; XUV Spectroscopy of Sungrazing Comets and determination of comet parameters; SOHO/UVCS data reduction and analysis with the Data Analysis Software (DAS), SOHO/LASCO data reduction with IDL and the Solar Software (SSW). Stereoscopic 3D reconstructions of prominences with data acquired by the STEREO/EUVI telescopes. Off-limb observations of the low corona with the HINODE/EIS spectrometer.
This will count as one of your downloads.
You will have access to both the presentation and article (if available).
Several metrology systems have been implemented in order to keep the formation-flying configuration. Among them, the Shadow Position Sensors (SPSs) assembly. The SPSs are designed to verify the sun-pointing alignment between the Coronagraph pupil entrance centre and the umbra cone generated by the Occulter Disk. The accurate alignment between the spacecrafts is required for observations of the solar corona as much close to the limb as 1.05 RΘ.The metrological system based on the SPSs is composed of two sets of four micro arrays of Silicon Photomultipliers (SiPMs) located on the coronagraph pupil plane and acquiring data related to the intensity of the penumbra illumination level to retrieve the spacecrafts relative position. We developed and tested a dedicated algorithm for retrieving the satellites position with respect to the Sun. Starting from the measurements of the penumbra profile in four different spots and applying a suitable logic, the algorithm evaluates the spacecraft tri-dimensional relative position. In particular, during the observational phase, when the two satellites will be at 150 meters of distance, the algorithm will compute the relative position around the ideal aligned position with an accuracy of 500μm within the lateral plane and 500 mm for the longitudinal measurement. This work describes the formation flying algorithm based on the SPS measurements. In particular, the implementation logic and the formulae are described together with the results of the algorithm testing.
The solar corona will be observed thanks to the presence on the first satellite, facing the Sun, of an external occulter producing an artificial eclipse of the Sun disk. The second satellite will carry on the coronagraph telescope and the digital camera system in order to perform imaging of the inner part of the corona in visible polarized light, from 1.08 R⦿ up to about 3 R⦿.
One of the main metrological subsystems used to control and to maintain the relative (i.e. between the two satellites) and absolute (i.e. with respect to the Sun) FF attitude is the Shadow Position Sensor (SPS) assembly. It is composed of eight micro arrays of silicon photomultipliers (SiPMs) able to measure with the required sensitivity and dynamic range the penumbral light intensity on the Coronagraph entrance pupil.
In the following of the present paper we describe the overall SPS subsystem and its readout electronics with respect to the capability to satisfy the mission requirements, from the light conversion process on board the silicon-based SPS devices up to the digital signal readout and sampling.
View contact details
No SPIE Account? Create one
