Presentation + Paper
31 August 2017 Handling and assembling of low-density foam structures fabricated by two-photon polymerization
O. Stein, Y. Liu, J. Streit, R. Cahayag, Y. Lu, N. Petta
Author Affiliations +
Abstract
Low-density foam targets for laser induced shock wave propagation experiments were produced via laser direct writing from polymeric materials. These targets were designed with dimensions of 2.0X0.25X0.3mm with a density of 100mg/cm3 and included a fully polymerized ablation layer, 15μm thick, written contiguously with the low density material in a single fabrication step. We developed a unique protocol in order to assist in the release and harvest of the foam targets from the glass substrate on which they were fabricated. The fabrication process, as well as the assembly and handling of these delicate brittle samples is described in this paper, demonstrating the flexibility, versatility and efficiency of two photon polymerization as fabrication technique that may complement conventional approaches for low density materials fabrication. An ongoing research effort is being conducted in order to reduce to the minimum the content of stitching defects between the target’s building blocks.
Conference Presentation
© (2017) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
O. Stein, Y. Liu, J. Streit, R. Cahayag, Y. Lu, and N. Petta "Handling and assembling of low-density foam structures fabricated by two-photon polymerization", Proc. SPIE 10354, Nanoengineering: Fabrication, Properties, Optics, and Devices XIV, 103540L (31 August 2017); https://doi.org/10.1117/12.2274564
Lens.org Logo
CITATIONS
Cited by 2 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Two photon polymerization

Foam

Computer aided design

Objectives

Polymers

Absorption

Scanning electron microscopy

Back to Top