Presentation + Paper
28 December 2022 Laser performance of LD side-pumped Er: YSGG crystal rods with different diameters
Author Affiliations +
Abstract
We demonstrate comparatively the laser performance of 970 nm laser diode (LD) side-pumped Er:YSGG crystals with a length of 85 mm and diameters of 2, 3, and 4 mm. The maximum average powers of 25.18, 25.74, and 20.41 W are achieved at 150 Hz and 200 μs, corresponding to the slope efficiencies of 30.01%, 31.47%, and 24.38%, respectively. The experimental results show that the Er:YSGG crystal rod with a diameter of 2 mm has no obvious advantage in laser output at low frequency and low pump power because the gain volume is small and the pump power cannot be fully absorbed, resulting in the gain saturation phenomenon. However, it exhibits the best laser output under high repetition rate and high pump power. The average power of 16.47 W obtained at 500 Hz is still not saturated. The beam quality factors M2 in the x and y direction are determined to be 3.15/3.12, respectively, which is significantly better than those of the rods with diameters of 3 and 4 mm. All the results indicate that the crystal rod with a smaller diameter has better thermal management due to its larger specific surface area and better cooling ability, which is conducive to improving laser performance under the high repetition rate and high pump power operation.
Conference Presentation
© (2022) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Lunzhen Hu, Dunlun Sun, Yuqiang Hou, Evgeny L. Gurevich, Andreas Ostendorf, and Qingchuan Guo "Laser performance of LD side-pumped Er: YSGG crystal rods with different diameters", Proc. SPIE 12310, Advanced Lasers, High-Power Lasers, and Applications XIII, 123100B (28 December 2022); https://doi.org/10.1117/12.2641626
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Crystals

Laser crystals

Semiconductor lasers

Thermal effects

Pulsed laser operation

Mid-IR

Back to Top