The scanning electron microscope (SEM) with photocathode technology was launched by retrofitting the photocathode electron gun to a commercial-based SEM system. In this SEM system, the excitation laser for photoelectron generation from the photocathode is synchronized to the scanning signal. SEM images were obtained by high-speed modulation of the photoelectron beam current using the photocathode SEM, where the location in the field of view and its irradiation current were arbitrarily selected on a pixel-by-pixel basis (Selective e-Beaming technology). As a demonstration experiment contributing to non-contact electrical inspection, low-voltage SEM imaging of MOS-FET structures in 3D-NAND flash memory was performed using this selective e-beam technology. As a result, changes in the voltage contrast of the drain electrode were observed in response to on/off selective electron beam irradiation to the gate electrode in the MOS-FET structure. As an extension of the selective electron beaming technology, a Yield Controlled e-beaming (YCeB) technology was invented to control the secondary electron yield generated in the entire field of view of the SEM image by feedback control of the laser power irradiating the photocathode to the intensity of each pixel in the SEM image. The YCeB image, in which the laser power intensity corresponding to the probe intensity is modulated so that the secondary electron yield generated in the entire field of view of the SEM image is constant, is a clearer image with less noise than the original SEM image.
|