Paper
2 July 1994 1/f noise in radio frequency SQUIDs made of niobium thin films
Michael Mueck, John Clarke, Christoph Heiden
Author Affiliations +
Proceedings Volume 2160, Superconductive Devices and Circuits; (1994) https://doi.org/10.1117/12.181001
Event: OE/LASE '94, 1994, Los Angeles, CA, United States
Abstract
Applications of Superconducting Quantum Interference Devices (SQUIDs) usually require high sensitivity at relatively low frequencies, often down to 1 Hz or lower. Excess noise, typically with a spectral density scaling inversely as the frequency, can substantially reduce the sensitivity of SQUIDs at low frequencies. We have studied 1/f noise in niobium rf-SQUIDs in some detail. To reduce any noise contribution of the readout electronics, a cryogenic preamplifier was used. When one measures the signal voltage of the SQUID directly, a pronounced 1/f noise was observed in all samples, and was nearly independent of the bias frequency used. The crossover between 1/f and white noise moved towards higher frequencies as the bias frequency was increased, because of a lower white noise contribution. The 1/f noise scaled approximately as the inductance of the SQUID. When operated in a flux locked loop, however, no 1/f noise could be observed above 0.5 Hz. Operating a rf SQUID in a flux locked loop can thus substantially reduce 1/f noise in rf SQUIDs.
© (1994) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Michael Mueck, John Clarke, and Christoph Heiden "1/f noise in radio frequency SQUIDs made of niobium thin films", Proc. SPIE 2160, Superconductive Devices and Circuits, (2 July 1994); https://doi.org/10.1117/12.181001
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Modulation

Inductance

Niobium

Electronics

Interference (communication)

Superconductors

Thin films

Back to Top