Paper
7 July 1995 Preload measurement in sleeve bolts using an ultrasonic technique
Author Affiliations +
Abstract
Sleeve bolts, which can provide an interference fit in a cylindrical hole by expanding during assembly, were used on an aerospace structural joint. Ultrasound was used to take measurements during preload application and monitoring. Ultrasonic bolt gages have commonly been used on regular bolts and studs, but not sleeve bolts. Ultrasound preload measurement on a sleeve bolt is different in many ways from that on a regular bolt. The pressure and friction on the sleeve bolt shank are absent or insignificant for regular bolts. Pressure and friction change depending upon initial conditions and applied load. The two factors affect the stress distribution inside the bolt and the ultrasound measurements. No published material was available for ultrasonic measurement of preload in sleeve bolts. The manufacturers of both the SLEEVboltR (PB Fasteners, Inc.) and the ultrasonic bolt gage were asked for information about this application. Since they had no experience in this application and were unable to help, the author developed the application descried in this paper.
© (1995) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Ajay M. Koshti "Preload measurement in sleeve bolts using an ultrasonic technique", Proc. SPIE 2455, Nondestructive Evaluation of Aging Aircraft, Airports, Aerospace Hardware, and Materials, (7 July 1995); https://doi.org/10.1117/12.213557
Lens.org Logo
CITATIONS
Cited by 2 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Ultrasonics

Head

Calibration

Ultrasonography

Temperature metrology

Velocity measurements

Manufacturing

Back to Top