Design, modeling, and performance of a high-force piezoelectric inchworm motor

Timothy P. Galante; Jeremy Eli Frank; Julien Bernard; Weicheng Chen; George Andre Lesieutre; Gary H. Koopmann

doi:10.1117/12.316945

27 July 1998 Design, modeling, and performance of a high-force piezoelectric inchworm motor

Timothy P. Galante, Jeremy Eli Frank, Julien Bernard, Weicheng Chen, George Andre Lesieutre, Gary H. Koopmann

Proceedings Volume 3329, Smart Structures and Materials 1998: Smart Structures and Integrated Systems; (1998) https://doi.org/10.1117/12.316945
Event: 5th Annual International Symposium on Smart Structures and Materials, 1998, San Diego, CA, United States

Abstract

A linear inchworm motor was developed for structural shape control applications. One motivation for this development was the desire for higher speed alternatives to shape memory alloy based devices. Features of the subject device include compactness (60 X 40 X 20 mm), large displacement range (approximately 1 cm), and large holding force capability (approximately 200 N). There are three active piezoelectric elements within the inchworm: two `clamps' and one `pusher'. Large displacements are achieved by repetitively advancing and clamping the pushing element. Although each pusher step is small, on the order of 10 microns, if the step rate is high enough, substantial speeds may be obtained (approximately 1 cm/s). In the past, inchworm devices have been used primarily for precision positioning. The development of a robust clamping mechanism is essential to the attainment of high force capability, and considerable design effort focused on improving this mechanism. To guide the design, a lumped parameter model of the inchworm was developed. This model included the dynamics of the moving shaft and the frictional clamping devices, and used a variable friction coefficient. It enables the simulation of the time response of the actuator under typical loading conditions. The effects of the step drive frequency, the pre-load applied on the clamps, and the phase shifts of the clamp signals to the main pusher signal were investigated. Using this tool, the frequency bandwidth, the optimal pre-load and phase shifts which result in maximum speed were explored. Measured rates of motion agreed well with predictions, but the measured dynamic force was lower than expected.

Citation Download Citation

Timothy P. Galante, Jeremy Eli Frank, Julien Bernard, Weicheng Chen, George Andre Lesieutre, and Gary H. Koopmann "Design, modeling, and performance of a high-force piezoelectric inchworm motor", Proc. SPIE 3329, Smart Structures and Materials 1998: Smart Structures and Integrated Systems, (27 July 1998); https://doi.org/10.1117/12.316945

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available