Paper
4 December 1998 Accessing guide first-order mode influence and optimize tolerances in multimode interference couplers
Author Affiliations +
Abstract
Influence of first order mode excitation in input/output waveguides of multimode interference couplers is analyzed. Emphasis in common mode rejection ratio penalty in 3-dB couplers as part of balance coherent detection receivers is encountered. Design analysis is carried out in InGaAsP/InP buried waveguides. Coupler behavior is modified basically when first order mode is excited at input waveguides. A drastically reduction of 25% couplers width tolerance is derived from first order mode partial presence (10% of full input optical power) in accessing waveguides. Some guidelines about width tolerance improvement in restricted interference couplers against general interference couplers is also reported. Couplers dependence on fabrication tolerance was described as a function of power distribution between different modes in multimode section.
© (1998) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
C. Vazquez, Candido Aramburu, Jose M. Sanchez-Pena, and Manuel Lopez-Amo "Accessing guide first-order mode influence and optimize tolerances in multimode interference couplers", Proc. SPIE 3491, 1998 International Conference on Applications of Photonic Technology III: Closing the Gap between Theory, Development, and Applications, (4 December 1998); https://doi.org/10.1117/12.328760
Lens.org Logo
CITATIONS
Cited by 4 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Waveguides

Tolerancing

Brain-machine interfaces

Waveguide modes

Receivers

Photonic integrated circuits

Wave propagation

Back to Top