Paper
24 July 2008 Design and fabrication of TES microcalorimeters for x-ray astrophysics in Japan
Author Affiliations +
Abstract
Our recent development of transition-edge sensor (TES) microcalorimeters for future X-ray astronomical missions such as DIOS is reported. In-house micromaching processes has been established aiming at prompt fabrication of TES devices. With a single-pixel TES microcalorimeter and an Au absorber, the energy resolution of 4.8 eV at 5.9 keV is achieved. 16×16 pixel arrays of TES microcalorimeters are successfully fabricated by using deep dry etching technique. The energy resolution is 11 eV and 26 eV with and without an Au absorber, respectively. The worse energy resolution than a single-pixel TES is due to large decrease of TES sensitivity and increase of transition temperature after etching. The reason for these phenomena is under investigation. In parallel, mushroom-type Au absorber structures are being tested. Furthermore, to precisely measure TES sensitivities and heat capacity, an experimental setup for impedance measurements is established.
© (2008) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Yuichiro Ezoe, Tomotaka Yoshino, Kazuma Mukai, Hiroshi Yoshitake, Hiroki Akamatsu, Kumi Ishikawa, Takayuki Takano, Ryutaro Maeda, Yoshitaka Ishisaki, Noriko Y. Yamasaki, Kazuhisa Mitsuda, and Takaya Ohashi "Design and fabrication of TES microcalorimeters for x-ray astrophysics in Japan", Proc. SPIE 7021, High Energy, Optical, and Infrared Detectors for Astronomy III, 70211X (24 July 2008); https://doi.org/10.1117/12.788155
Lens.org Logo
CITATIONS
Cited by 3 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Gold

Silicon

X-rays

Etching

Deep reactive ion etching

Semiconducting wafers

X-ray astronomy

Back to Top