A multilayer antireflection coating based on titanium oxide and silicon oxide has been developed. The dispersions of the refractive index and absorption coefficient of these materials are obtained in a wide spectral region of 500-8000 nm. Taking into account these dispersions, a calculation was made of a four-layer interference coating with ZGP substrate antireflection in the range of 2097 nm and 3500-5000 nm, with residual reflection R≤0.2% and R≤2.1%, respectively. The modes of coating deposition by the method of ion-beam sputtering on the substrate are selected.
The paper defines the laser-induced damage threshold from the fluence and the peak power of GaSe and GaSe:In single crystals upon exposure to nanosecond radiation in the two-micron range and assesses the influence of test radiation energy parameters (pulse repetition rate, pulse duration) on the damage threshold. Laser-induced damage threshold was determined with the parameters of the incident radiation close to the pump radiation parameters of promising dual-wavelength optical parametric oscillators (effective pump sources for THz difference frequency oscillators): wavelength is ~ 2.1 μm, pulse repetition rate is 12 and 20 kHz, pulse duration is 18-22 ns.
The paper shows the effect of magneto-rheological (MPO) polishing of a ZnGeP2 on the surface roughness. The extreme level of surface roughness of the ZnGeP2 Ra=1.54Å was recorded. Analysis of the topography of the sample surface before and after magnetic polishing showed that after the classical polishing technology, the relief of the surfaces was formed under the influence of multidirectional movement of the working tool, there are single extended scratches up to 1.3 nm deep. The topography of the sample surface after MPO polishing does not contain these scratches and is represented by a less textured profile formed under the influence of MPO fluid.
The paper shows an increase in the threshold energy density of laser radiation at a wavelength of 2091 nm as the temperature decreases from 0º С to -60º С until the optical breakdown of a ZnGeP2 (ZGP) single crystal sample is reached. With a decrease in temperature from 0º to -60º C, a sharp increase in the threshold energy density is observed from 1.6 to 2.6 J/cm2, with a laser beam diameter of 270 μm, and from 3.2 to 10.2 J/cm2 with a diameter of 100 μm (by 1.5 and 3 times, respectively).
KEYWORDS: Digital holography, Holograms, Digital recording, Pulsed laser operation, 3D image reconstruction, Particles, Image registration, Transmittance, Signal to noise ratio, Digital cameras
The quality of particle images reconstructed from digital holograms depends on the choice of parameters for digital holograms recording — the exposure time of a digital camera, the laser radiant power, and the laser pulse duration. The problem of automatically choosing the parameters for recording a digital hologram under conditions of a changing optical transmission of the aquatic medium while studying plankton in its habitat arises. Using the maximum of digital hologram contrast as a criterion for choosing the parameters for recording a digital hologram to obtain the best quality particles images reconstructed from a digital hologram is proposed.
The effect of the designed antireflection coatings based on Nb2O5/Al2O3 and Nb2O5/SiO2 pairs of materials on the laserinduced damage threshold (LIDT) of ZnGeP2 crystals at a wavelength of 2097 nm is shown. The coating was applied using the ion-beam sputtering (IBS) method. The LIDT of the sample coated with Nb2O5/SiO2 was W0d = 1.8 J/cm2. The LIDT of a sample coated with Nb2O5/Al2O3 is W0d = 2.35 J/cm2. The presence of silicon conglomerates in the antireflection coating leads to a decrease the LIDT of a nonlinear crystal due to local thermomechanical stresses and scattering of the incident laser radiation.
The generation of terahertz (THz) radiation using a ZnGeP2 (ZGP) large-aperture photoconductive antenna (PCA) was demonstrated. The semiconductors were excited above and below the bandgap (400 and 800 nm) by a femtosecond Ti:sapphire laser. The THz pulse waveform generated by the ZGP antenna was measured using a time-domain spectroscopy technique. The antenna’s THz pulse energy dependence on the optical pump energy was measured, and saturation fluence and carrier mobility were estimated. The ZGP and a chemical vapor deposited ZnSe-based PCA were compared.
Conditions for the formation of THz radiation in ZnGeP2 single crystals when generating a difference frequency are considered. It is shown that effective THz radiation requires two-frequency laser pumping sources with a generation pulse duration of < 1 ns. It is proposed to use IR radiation as such a source dual-wavelength optical parametric oscillator based on the KTP singlecrystal with pumping by Nd:YAG lasers with active Q-switching with simultaneous synchronization mode.
Volumetric defects in ZnGeP2 single crystal have been visualized by using the digital holography camera. Type, geometrical sizes and positioning of founded defects were determined. Based on this information researching zones were chosen on the test ZnGeP2 plate. Measurements of absorption coefficient and refractive index in THz range were carried out. It is shown that in the frequency range 0,3-1 THz the difference of absorption coefficients reaches the value Δα = 0.2 cm-1 between “clear” zones and zones with volumetric defects. In same time, maximum difference by refractive index is about Δnmax = 0,0015.
In this paper presented a series of experiments determine the spectral characteristics of random lasing in lasers with agglomerated nanoparticles metals and dielectrics. The data allowed us to establish that, in the active heterogeneous environment, there are various gain effects of lasing the impact of which is determined nanoparticles concentration.
Access to the requested content is limited to institutions that have purchased or subscribe to SPIE eBooks.
You are receiving this notice because your organization may not have SPIE eBooks access.*
*Shibboleth/Open Athens users─please
sign in
to access your institution's subscriptions.
To obtain this item, you may purchase the complete book in print or electronic format on
SPIE.org.
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.